12/22/2023 0 Comments Netmap iptablesBest load balancing set up with zeroshell for an internet cafe.VPN – Client connects without certificate.Block one host of a network on the DNS but not the whole network.IPs blocked by a firewall drop rule cannot be pinged but still pass through NAT.How to connect with available Wifi Or hotspot?.VLAN firewall rules for LAN and 1 VLAN setup.Multiple SSIDs in Orange Pi Zero (ZeroShell 3.8.2a).Kerberos 5 Username contain strange caracters.i want to make a splash page capable of sending messages to zeroshell. VPN HTTP/S connection through zeroshell.correct the rules in the Scripts and the static routes, reboot and try… once again 0.0 (LAN B) through 172.20.0.0 which is NAT address. So I have to NAT each remote LAN with following address: I want to connect to remote LAN which have same IP address: 192.168. for reaching a server located in siteB at 192.168. The commands above will translate the whole network portion of the ip address, leaving intact the host portion, so, for eg. Iptables -t nat -I PREROUTING -i VPN00 -s 192.168.2.0/24 -d 192.168.1.0/24 -j NETMAP -to 192.168.0.0/24Įnable the script, save, look if the rules are applied (in case, reboot) iptables -t nat -nvL Try as follows … firstly, remove all virtual server rules, as well as the static routes regarding the remote networks, then add, Scripts/Cron, NAT and Virtual Servers script, these lines
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |